CE-9102KT - Johnny Joint Install Tool (For JK/TJ/LJ/XJ/MJ/ZJ Axle Housing JJs)
Details
Details
RockJock's Axle Housing Johnny Joint Installation Tool is machined from 2 in. OD steel bar stock and features a .938 in. ID bore. Tool is intended to fit over the pivot ball flange on an axle housing Johnny Joint and butt up against the Johnny Joint outer barrel providing a solid point for driving the joint into a front axle housing casting with a hammer.
Kit Fits:
- Included component in our TJ/LJ/XJ/MJ/ZJ axle housing Johnny Joint kit
- Included component in our TJ/LJ/XJ/MJ/ZJ axle housing Johnny Joint kit
- Included component in our JK axle housing Johnny Joint kit
Component Specs.:
- OD = 2.000 in.
- Height = 2.500 in.
- Bore = .938 in. ID x .750 deep
- Material = 12L14 steel
- Finish = raw steel
Notes:
- Not for use with JL/JT axle housing Johnny Joint kits! For the JL/JT tool, see: and
- Not for use for installing axle housing Uni-Balls! For the Uni-Ball tool, see: and