Weld-on "Tombstone" Bracket only out of our CE-9102K Johnny Joint front housing bracket kit. This bracket allows you to replace the factory rubber bushing on your stock Dana 30 or 44 differential housing (or 2WD beam) by cutting the top of the factory passenger's side upper control arm bracket off, sliding this bracket inside the existing bracket's base, welding and installing the 2 in. Johnny Joint internals into the new bracket. This part number is the Tombstone bracket with stock TJ/LJ/XJ/MJ Johnny Joint internals installed (center ball is 2 in. wide x .500 in. thru-hole). 1/2 in. greasable bolt included. Raw finish.